What codes are you getting they need fixed first
Forced Stationary Regen Stopping
2015 Ram 1500 EcoDiesel
I have exhaust filter 100% see dealer - limp mode message.
I am trying to use alfa obd stationary Regen tool, and I can get the Regen to start with the following process:
MAR
clear faults
Start DPF Regeneration Enabling
Turn off vehicle and open door
Wait for all lights to turn off
Start vehicle
Connect alfa again
Start Particulate Filter Regeneration
RPMs climb to 2500, but error codes return and the process quits on its own after about two minutes. I can smell the smell of regen, though.
Any tips would be appreciated.
I have exhaust filter 100% see dealer - limp mode message.
I am trying to use alfa obd stationary Regen tool, and I can get the Regen to start with the following process:
MAR
clear faults
Start DPF Regeneration Enabling
Turn off vehicle and open door
Wait for all lights to turn off
Start vehicle
Connect alfa again
Start Particulate Filter Regeneration
RPMs climb to 2500, but error codes return and the process quits on its own after about two minutes. I can smell the smell of regen, though.
Any tips would be appreciated.
1 - 3 of 7 Posts
The P2002 means its sensing pm or soot getting past the dpf aseembly. You could try pulling the dpf and inspecting but it might be time to replace it. Is the insides of your tailpipes black?
If you want to go stage 2 then no need to replace the dpf. But make sure whatever tuner you go with knows about the issue so they can address it.
1 - 3 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
RAM 1500 Diesel Forum
Ram1500Diesel.com is the largest RAM 1500 Diesel forum community on the web with discussions on 2014+ Ram EcoDiesel trucks. Discuss performance mods, towing capacity, wheels, tires, lift kits, and much more!
Full Forum Listing
Top Contributors this Month
View All
biodiesel
82 Replies
keiths487too
76 Replies
Dieseldragon
59 Replies
